7
Keep the appliance and its cord out of
reach of children less than 8 years.
Never leave an empty carafe on the
warming plate, as the carafe may crack.
This equipment is labelled in compliance
with the European Directive 2012/19/EC on
waste electric and electronic equipment
–
WEEE. The Directive specifies the
requirements for collection and
management of waste electric and
electronic equipment effective in the entire
European Union.
Before using the appliance for the
first time
For the perfect flavour, run the coffee
brewing cycle with water only (without
coffee) two or three times. Each time the
water runs through the appliance, unplug it
and let it cool down for five minutes. Then
repeat the cycle with fresh water.
Brewing coffee
1. Open the water tank cover and fill the
water tank with drinking water. The water
level should not exceed the MAX level as
indicated on the water level gauge.
2. Place the funnel into the funnel support.
Make sure it is assembled correctly,
otherwise the water tank cover cannot be
closed. Place the permanent filter in the
funnel.
3. Add ground coffee into permanent filter.
Usually a cup of coffee needs a level
spoon of ground coffee, but you may
adjust the amount according to personal
taste. Close the water tank cover
completely.
4. Place the carafe onto the warming plate
horizontally.
5. Plug the power cord into the outlet. The
LCD display indicates “12:00”.
6. Press the ON/OFF button. The ON/OFF
indicator lights up in red and the
appliance begins to operate.
Note: The brewing process may be
interrupted at any time by pressing the
ON/OFF button. The ON/OFF indicator
will switch off, indicating your coffee
maker is shut off.
Note: During the brewing process, the
“PROG”, “HOUR” and “MINUTE” buttons
do not have any effect.
7. The brewing process can be interrupted
at any time by pressing the ON/OFF
button, The ON/OFF indicator will switch
off. The appliance will continue brewing
once the ON/OFF button is pressed
again.
Note: You can take out the carafe and
serve the coffee at any time. The
appliance will stop dripping automatically.
This pause, however, may not exceed 30
seconds.
8. When the brewing process is complete
(about one minute after the coffee stops
dripping), you may remove the carafe to
serve the coffee.
Note: The amount of coffee will be less
than the amount of water you have
added, since some water is absorbed by
the coffee grounds and some may
adhere to the plastic parts.
9. If you do not wish to serve the coffee
immediately after the brewing process is
finished, keep the coffee maker plugged
in and switched on. Coffee can be kept
warm on the warming plate. Forty
minutes after the appliance was switched
on with the ON/OFF button, the
appliance will be switched off
automatically, if it has not been manually
disconnected after the end of the brewing
process. For optimum coffee taste, serve
it immediately after brewing.
10. Always turn off the coffee maker and
unplug the power cord when not in use.
Note: Be careful when pouring the
coffee. The coffee that has just been
brewed is very hot and you could scald
yourself.
Delay function
If you do not want the coffee maker to start
operating immediately
– for example, if it is
8:00 a.m. right now, but you want your coffee
maker to start operating automatically at
1:00 p.m., first follow steps 1 to 5 from the
section “USING YOUR COFFEE MAKER”,
and then set the automatic start function as
follows: