background image

CC-400HF HI-FLO 0121

4

16.

   The unit is equipped with an automatic by-pass valve that recirculates water inside 

the pump when the spray gun trigger is released. Although the unit has a thermal 

discharge valve for protection, avoid leaving the unit running in by-pass mode for 

more than five (5) minutes.

17.

  

IMPORTANT:

 Do not carry the unit by the pump guard as it is not designed to be 

used as a handle!!!

18.

  

DO NOT ADJUST BYPASS PRESSURE:

 The bypass pressure is factory set – 

adjustments may damage unit!

Electrical Precautions

1.

   Make certain that the power source conforms to the requirements of  

the equipment.

2.

   Keep all connections dry and off the ground. Do not handle the unit or electrical 

plug with wet hands.

3.

   Unplug the power cord when servicing the unit or leaving the machine unattended.

4.

   Do not pull on the power cord or pull the cord around sharp corners. Keep the cord 

away from hot surfaces. When unplugging the power cord, grasp the plug – not  

the cord.

5

  

WARNING:

 The cords, wires, and/or cables supplied with this product may contain 

chemicals, including lead or lead compounds, known to the State of California to 

cause cancer and birth defects or other reproductive harm. Always wash hands 

thoroughly after handling the unit.

6.

  

GROUNDING INSTRUCTIONS:

 For proper protection this product must be 

grounded. Always plug the power cord into a properly grounded receptacle. Never 

remove the grounding prong from the power cord plug or use an adapter that 

eliminates ground.

7.

  

GROUND FAULT CIRCUIT INTERRUPTER:

 This unit is provided with a Ground 

Fault Circuit Interrupter built into the power cord plug to prevent electrocution. DO 

NOT RUN THE UNIT WITHOUT THIS DEVICE!! If replacement of the plug or cord 

becomes necessary, use only identical replacement parts that include  

GFCI protection.

8.

  

EXTENSION CORDS:

 Use only extension cords that are intended for outdoor 

use. These extension cords are identified by a marking “Acceptable for use with 

outdoor appliances; store indoors while not in use.” Use only extension cords having 

an electrical rating not less than the rating of the product. Do not use damaged 

extension cords. Examine extension cord before using and replace if damaged. Do 

not abuse extension cord and do not yank on any cord to disconnect. Keep cord 

away from heat and sharp edges. Always disconnect the extension cord from the 

receptacle before disconnecting the product from the extension cord.

SAVE THESE INSTRUCTIONS

Summary of Contents for Hi-Flo CC-400HF













Reviews: