FUNCTION
RADIO
TAPE/OFF
CD/MP3
12. CASSETTES
The quality and condition of the cassette tapes you use will have a direct effect on the
performance of this set.
Low quality tapes tend to break and stretch and a broken tape can easily become entangle
in the drive mechanism, causing major damage. Stretched tapes will run at uneven speeds
and will distort anything recorded on them.
Use only well-known brands of tapes.
Use of C-120 (120 minutes) cassette is not recommended. The extreme thinness of
this tape may result in breakage or other failures.
This set is not designed for CrO2, Fe-Cr or METAL tape use. Therefore, be sure to use
named brand normal cassette tapes.
h
h
h
CASSETTE TAPE SELECTION
TO PLAY A CASSETTE TAPE
AUTOMATIC LEVEL CONTROL (ALC)
This product utilizes the latest Automatic
Level Control circuitry, therefore, it is not
necessary to adjust the Volume Control
when recording. This circuit automatically
records at the correct level and prevents
over loading.
NOTE:
While recording you may adjust
the Volume Control as desired
without affecting the recording
operation.
1. Open the cassette door by pressing the
cassette STOP/EJECT button.
2. Insert a cassette with the exposed tape
facing upwards and the full reel on the
right (unit plays from right to left) into
the guides on the inside of the cassette
door.
3. Close the cassette door.
4. Set the function switch to the TAPE
playback.
5. Press the cassette PLAY button to start
the tape playing.
6. Adjust
the
VOLUME
control to a
comfortable listening level.
7. To stop the tape playing, press the
STOP EJECT button. Press the button
again to open the cassette door and
eject the tape.
During play, when the end of the
tape is reached the PLAY button will pop up
and play will stop. To play the other side of
the tape, remove the cassette, turn the
cassette over so that the full reel is on the
right, replace the cassette and press the
PLAY button.
NOTE:
/
MIN
VOLUME
MAX
10.
ANTI-SHOCK PROTECTION
A special circuitry inside the player guarantees that there will be no sound skipping when
the player is subject to shock and shaking in music playback. The laser scans the CD/MP3
disc and saves data for up to 60/120 seconds ahead of where the playback is on the disc.
In case of shocks or shaking or vibrations, the player reads from the memory until the laser
can read CD again. But if there is too much vicious vibration or shaking exerted on the
player, the player may malfunction and sound skipping is caused.
When this happens, place the player on a level table where no vibration will be brought.
Normal sound will resume immediately.
11. EQ SELECTION
Press EQ/PROGRAM button continuously
during disc playback mode to select EQ
s o u n d
e ff e c t s
a m o n g
D B B ,
P O P,
CLASSICAL, JAZZ, ROCK, and NORMAL.
EQ/PROG.
