COMMAND ES UNA MARCA REGISTRADA DE 3M
1/16in.
2
3
3
Locate the sites for the
screws by measuring the
distance from the center from
one keyhole slot to the other.
Mark the locations to install
the 2 screws. Carefully drive
screws in, leaving a little over
a 1/16” gap.
Slide the product’s 2 keyhole slots
over the 2 screw heads until both
sides are captured by the narrow
ends the keyhole slots.
EASY INSTALLATION WITH COMMAND
®
STRIPS BY 3M
OPTION A
SCREW MOUNT INSTALLATION
OPTION B
CLICK!
1
2
3
Before 1st use, plug in USB wall
charger (not included) and micro
USB cord (included) to charge
product until indicator light
changes from red to green
Clean surface with rubbing
alcohol. Separate strips. Press
two strips together until they
click. Repeat with 2nd set of
strips.
Remove one side of liners.
Place each pair of strips as
shown. Press firmly for 30
sec.
Remove remaining liners and press
onto surface. Press each side firmly
for 30 sec.
4
TO REMOVE PRODUCT
Grab edge of light and peel
from surface. Do not pull
straight off.
REMOVE PRODUCT TO:
1. Charge Battery.
2. Use as a portable light.
Remount by lining up strips
and press firmly.
12 IN. RECHARGEABLE MOTION BAR
BARRA DE MOVIMIENTO RECARGABLE DE 12 PULGADAS
(PÁGINA 3)
Model #:
RE1250-WHG-12LFR-G
48 in.
1
Before 1st use, plug in USB wall
charger (not included) and micro
USB cord (included) to charge
product until indicator light
changes from red to green
48 in.
REMOVAL
seconds
30
CAUTION:
Do not hang over beds or on wallpaper. Mount again with Command
®
Small Picture Hanging Strips.
IMPORTANT:
Failure to follow instructions carefully may cause damage.
SLOWLY
2
1
TO REMOVE STRIPS PERMANENTLY
Never pull the strip away from
the surface! Always pull along
the surface.
Stretch each strip slowly against the
surface at least 6” to release.
REEMPLAZO DE LA BATERÍA