Good Display GDE060BAFL-T, Quick Start Manual

Page: 14 / 17

9. Handling, Safety and Environment Requirements
Warning
The display glass may break when it is dropped or bumped on a hard surface. Handle
with care. Should the display break, do not touch the electrophoretic material. In case
of contact with electrophoretic material, wash with water and soap.
Caution
The display module should not be exposed to harmful gases, such as acid and alkali
gases, which corrode electronic components.
Disassembling the display module can cause permanent damage and invalidates the
warranty agreements.
Observe general precautions that are common to handling delicate electronic components.
The glass can break and front surfaces can easily be damaged. Moreover the display is
sensitive to static electricality and other rough environmental conditions.
Precautions
(1) Do not apply pressure to the EPD panel in order to prevent damaging it.
(2) Do not connect or disconnect the interface connector while the EPD panel is in
operation.
(3) Do not touch IC bonding area. It may scratch TFT lead or damage IC function.
(4) Please be mindful of moisture to avoid its penetration into the EPD panel, which
may cause damage during operation.
(5) If the EPD Panel / Module is not refreshed every 24 hours, a phenomena known as
“Ghosting” or “Image Sticking” may occur. It is recommended to refreshed the
ESL /EPD Tag every 24 hours in use case. It is recommended that customer ships or
stores the ESL / EPD Tag with a completely white image to avoid this issue
(6) High temperature, high humidity, sunlight or fluorescent light may degrade the
EPD panel’s performance. Please do not expose the unprotected EPD panel
to high temperature, high humidity, sunlight, or fluorescent for long periods of
time.
www.e-paper-display.com 6.0 inch Series
GDE060BAFL-T
GOOD
DISPLAY