10
Manual
6 Connecting:
1. Connect the coaxial cable from the LNB (satellite dish) to the Satellite socket of the SAT
FINDER.
2. Connect the coaxial cable of the receiver input to the receiver socket of the SAT FINDER.
7 Operating:
1. Switch on the Satellite receiver. The SAT FINDER starts automatically.
2. Set your dish to the proper azimuth and elevation setting. (The information should be
supplied with your satellite dish.)
3. Adjust the volume key until the signal strength displays a maximum.
4. Peak the the signal by slowly moving the azimuth and elevation of the dish. The higher
the value, the better the signal. If a full scale is shown, adjust the
3
ATT key to reduce
the incoming signal to a lower level. Continue to move the dish until having the highest
possible meter reading and and the highest possible buzzer pitch.
5. If the incoming signal is too low at all, increase the incoming signal with
4
ATT.
6. After finishing adjusting the dish, remove the cables from the SAT FINDER and recon-
nect the LNB to the receiver.
8 Care, Maintenance, Storage, and Transport:
ATTENTION! There is a risk of electric shock and short circuit!
• The product is maintenance free.
• Use a dry linen cloth to clean your product, or use a slightly moist cloth for heavy stains.
Look out for live cables of your device during cleaning!
• Attend avoiding risks of stumbling by installing the cables.
• Avoid places with high temperatures, humidity, or places which can become wet, also
during care, maintenance, storage, and transport.
• Reposit the original packaging for transporting.
• Follow the safety symbols on the packing during transport.
9 Troubleshooting:
Problem
Help
no buzz
- Turn on the volume key lateral to the device.
- Make sure all devices are switched on..
- Check all cables and connections for damages.
