PANEL DESCRIPTIONS
Rear Panel
1.
Dual link DVI IN
: DVI input source
2.
Dual link DVI OUT
: distributed DVI output 3
3.
Dual link DVI OUT
: distributed DVI output 4
4.
DIP Switch
: For EDID learning
5.
RS232 IN
: for firmware update and control use
6
.
Power Signal LED
7.
+5V DC
interlocking power jack: connect to 5V 4A interlocking power supply unit
DIP Switch
1. Only DVI output 3 can be used to learn EDID
Pin #1
Pin #2
EDID feature
OFF (
)
OFF (
)
Default - Dual Link Mode
OFF (
)
ON (
)
Default - Single Link Mode
ON (
)
ON (
)
EDID Learning Mode
ON (
)
OFF (
)
Reserved Mode
3
HARDWARE INSTALLATION
1. Connect the output display to DVI output3
2. Adjust the DIP switch to EDID Learning Mode [ON,ON] (
,
)
3. Plug out and then plug in the power adapter
4. The power indication LED will start flicking
5. After the EDID Learning is done, LED will stop flicking
CONNECTION DIAGRAM
Broadcasts DVI signal to 4DVI displays!
1. Switch off all devices, including monitors.
2. Connect to the receivers.
3. Connect a DVI source to the DVI In.
4. Plug in 5V DC power supply unit.
5. Power on the DVI monitors.
6. Power on the DVI source.
4
