8
0
HARDWARE INSTALLATION
1. Connect a HDMI or DVI source (such as a Blu-ray Disc player) to the transmitting unit CV-57KJ-TX.
2. Connect a HDMI or DVI display (such as a LCD TV) to the receiving unit CV-57KJ-RX.
3. Connect IR Blaster/Receiver to both TX and RX units.
4. Connect a Cat-5/5e/6 cable between the transmitting and receiving units.
5. Make sure this Cat-5/5e/6 cable is tightly connected and not loose.
6. Plug in 5V DC power supply unit to the power jack of the receiving unit CV-57KJ-RX.
7. Plug in 5V DC power supply unit to the power jack of the transmitting unit CV-57KJ-TX.
8. If you see flickering or blinking image on the display, please adjust the rotary control switch to improve
the cable skew. MAX stands for the strongest HDMI signal level for longest possible transmission
length while MIN stands for the weakest HDMI signal level for short transmission length. Please adjust
the signal level from MIN to MAX and stop turning the rotary switch whenever the audio/video is
playing normally. Inappropriate signal level setting may cause overpowering issue that would shorten
the product life significantly!
EDID LEARNING
1. Turn off CV-57KJ-TX and disconnect the Cat.5/5e/6 between CV-57KJ-TX and CV-57KJ-RX.
2. Connect the HDMI display to "
HDMI IN
" on the CV-57KJ-TX with a HDMI cable.
3. Set "
MODE
" on the transmitting unit CV-57KJ-TX at
H
.
4. Turn on the CV-57KJ-TX.
5. The LED on the RJ45 of CV-57KJ-TX will dim and light again, which indicates the EDID learning
procedure is complete.
6. Unplug the HDMI cable from the display and follow the instruction in [Hardware Installation] to set up
the CV-57KJ and enjoy the experience.
