-
5-
Rear Panel
9.
+12V DC:
Connect to a 12V power supply unit
10.
Indicator LED:
Power LED
11.
IR Receiver:
Infrared 3.5mm socket for plugging in the extension cable of IR receiver
12.
IR Blaster:
Infrared 3.5mm socket for plugging in the extension cable of IR blaster
13.
Micro-USB:
for F/W update
14.
RS-232(terminal block format):
The order of RS-232 pin are TX, RX, GND (from the left side to the right)
15.
Stereo OUT:
Connect to analog stereo audio speaker
16.
Stereo IN:
Connect to analog stereo audio source
17.
Indicator LED:
HDMI out signal LED
18.
Indicator LED:
HDMI in signal LED
19.
HDMI OUT:
Connect to a HDMI display with a HDMI male-male cable
20.
HDMI IN:
Connect to a HDMI source with a HDMI male-male cable
-
6-
IR PASS-THROUGH
[IR Extenders]
IR Blaster
IR Receiver
[IR Sockets]
IR BLASTER:
plug in the IR blaster to emit all IR command signals received from the IR receiver from the other
end to control the devices corresponding to the IR signals.
IR RECEIVER:
plug in the IR receiver to receive all IR command signals from the IR remote controls of the
corresponding devices.
[Definition of IR Earphone Jack]
IR Blaster
IR Receiver
You can buy any IR extension cables in the market that are compatible to the definition of the
IR sockets for the extender if necessary for replacement use. However, IR cables longer than
2m (6-ft) may not work.
Incorrect placement of IR Blaster and Receiver may result in the failure of the
IR extenders. Please check carefully before plugging in the IR extender to the
respective IR sockets. Warranty will not cover the damage.
CAUTION!