FS 190
Operating instructions
- 6-
02821900988
5005967-04
In the event of safety-relevant modifications or changes in the behaviour of the product, stop the
product immediately and report the malfunction to the competent authority/ person.
Do not remove or make inoperative any safety devices the product is equipped with. Never make any
modifications, additions or conversions which might affect safety without the manufactur
er’s/distribu-
tor’s prior consent! This also applies to the installation and adjustment of safety devices as well as to
welding and drilling work on supporting structures.
Damaged or worn parts of the product must be replaced immediately. Use genuine spare parts only.
All spare parts and tools must comply with the technical requirements specified by the manufacturer/
distributor. Adhere to the legally prescribed preventive maintenance and inspection intervals or those
specified in this operating manual!
All maintenance and repair activities must be performed by qualified personnel using suitable tools
and other suitable workshop equipment.
Observe the fire alarm and fire fighting measures. The personnel must be made familiar with the
location and handling of fire extinguishers!
2.3 Selection and qualification of person
Any work on and with the product must be executed by reliable person only. Statutory minimum age
limits must be observed!
The product must be operated or serviced by trained or properly instructed person only. Clearly define
the individual responsibilities of the person for operation, set-up, maintenance and repair.
Make sure that only authorized work on or with the product.
Define the machine operator’s responsibilities -also with regard to observing road traffic regulations-,
providing the operator with the authority to refuse instructions by third parties that are contrary to
safety.
Do not allow persons to be trained or instructed or persons taking part in a general training course to
work on or with the product without being permanently supervised by an experienced person.
Work on the electrical system and equipment of the product must be carried out only by a skilled
electrician or by properly instructed persons working under the supervision and guidance of a skilled
electrician and in accordance with electrical engineering rules and regulations.
2.4 Normal operation of the machine
Before beginning work, familiarize yourself with the surroundings and circumstances of the site, such
as obstacles which might impede work or traffic, the soil bearing capacity and the required safety
measures, e.g. barriers separating the work site from public traffic. Check the range in gas-, water-
and power supply lines before working.
Avoid any operational mode that might be prejudicial to safety!
Take the necessary precautions to ensure that the machine is used only when in a safe and reliable
state. Operate the machine only if all protective and safety-oriented devices, such as removable
safety devices, emergency shut-off, sound-proofing elements and exhausters, are in place and fully
functional.
Each time before you start working, check the product for obvious damage and defects. Any changes
(including changes in the performance or behaviour of the product) must be reported to the competent
authority/ person immediately. In the event of malfunctions or changes in the machine’s behaviour,
stop the product immediately and secure it against restarting. Have any defects rectified immediately!
The machine is designed for use in daylight! The machine operator/ owner must ensure sufficient
workplace lighting for non-illuminated work sites!
Take precautions to ensure that the operator always has an adequate view of the work. Before leaving
the machine always secure it against inadvertent movement and unauthorized use!
During start-up and shut-down procedures always watch the indicators in accordance with the
operating instructions. Before starting up or setting the machine in motion, make sure that nobody is at
risk. Always keep at a distance from the edges of building pits and slopes.
