8
9
a
d
c
e
b
e
g
f
On-Off and call volume regulator
(only on T-901VD telephone).
Place the monitor at right angles to the connector
and align the attaching holes of the monitor
with the attachment hooks of the connector,
as it is shown on the drawing.
Lock out the monitor. Press the right side
till the attachment clip locks the monitor
firmly.
To disassemble the monitor from the connector,
use a plain screwdriver to release the
attachment clip. Remove the monitor from
the connector, with special attention do not
falls.
ix the monitor.
F
MONITOR INSTALLATION
hanging the front film.
C
The monitor is supplied with a reversible front film,
that allow the owner to choose between two colors.
To change the front film, remove the front plate
by inserting a plain screwdriver in the triangle marks,
as it is shown on the drawing.
a.
b.
c.
d.
e.
f.
g.
Telephone handset.
Speaker grille.
Microphone hole.
Subjection hole.
Telephone cord connectors.
Door release push button.
Hook switch.
escription of the T-901 and T-
D
901VD telephones.
To open the telephone insert a plain screwdriver
into the slots and rotate it as shown.
Avoid to place the telephone near to heating sources,
in dusty locations or smoky environments.
The telephone can be fixed using an electrical embedding
box or directly on the wall, as shown on the picture.
If the telephone will be installed directly over the wall,
drill two holes of Ø6mm. on the specified positions,
using 6mm. wallplugs and Ø3,5 x 25mm. screws.
Pass the installation wires through
the corresponding hole and
connect them as shown on the
installation diagrams.
Close the telephone as shown on the picture.
Once the telephone is closed, connect the handset
using the telephone cord and put it on the craddle.
TELEPHONE INSTALLATION
