DOOR PANEL INSTALLATION
TELEPHONE INSTALLATION
3
4
inal adjustments.
F
If after starting the system it's considered that
the audio volume isn't correct,
proceed with the necessary adjustments
as shown.
Place the nameplate label.
lose the door panel.
C
Fix the door panel by using the supplied screws.
Break the bottom flange to pass the cables through.
Pass the wiring through the hole made in
the bottom part of the embedding box.
Level and flush the embedding box.
Once the embedding box is placed,
remove the protective labels
from the attaching door panel holes.
reparing the embedding box.
P
a.
b.
c.
d.
e.
f.
g.
h.
i.
a
d
c
e
g
b
i
h
e
f
To open the telephone insert
a plain screwdriver into the slots and
rotate it as shown.
Avoid to place the telephone near to heating sources,
in dusty locations or smoky environments.
The telephone can be fixed using an electrical embedding
box or directly on the wall, as shown on the picture.
If the telephone will be installed directly over the wall,
drill two holes of Ø6mm. on the specified positions,
using 6mm. wallplugs and Ø3,5 x 25mm. screws.
Pass the installation wires through
the corresponding hole and
connect them as shown on the
installation diagrams.
Close the telephone as shown on the picture.
Once the telephone is closed, connect the handset
using the telephone cord and put it on the craddle.
escription of the T-920 and T-922
D
telephones.
Telephone handset.
Speaker grille.
Microphone hole.
Subjection hole.
Telephone cord connectors.
Additional push button (T-922 only).
Door release push button.
Call reception volume control.
Hook switch.
