INTERFACE ADJUSTMENTS
49
PROGRAMMING
This unit needs to be programmed so as to configure the adjustable parameters of the system to
the needs of the user and the installation
With the system in standby, access the programming mode by picking the handset up of the
telephone and entering the PIN with the telephone keypad using the following sequence:
“##0 + PIN”.
Once the programming mode is accessed, the programming sequence will be done by fields. See
the table on page 51.
To verify the state of programming, and if the sequence is correct or not, the handset's
speaker will emit the following tones:
Programming mode accessed: Five short tones.
Correct field code: Two medium-duration tones.
Correct code value: Four medium-duration tones.
Error: One long-duration tone.
.
To ensure a correct programming of the system, calls should not be made from either the audio
door entry system or from the telephone line while in programming mode.
If no keys are pressed during one minute the system will save the entered data and exit the
programming mode.
When finished, exit the programming mode by replacing the handset.
The adjustments will be automatically saved.
D
escription of the dip switches:
The telephone interface has two dip switches beside the operation LEDs, which the installer can
access and configure without having to open the cover:
Dip switch 1:
OFF: Normal mode.
ON: Divert mode always enabled.
Dip switch 2:
OFF: No function.
ON: Changes the PIN to the factory standard.
Factory default.
*
*
Programming the interface:
*