8
9
Monitor
Telephone
Door panel
If after starting the system it's considered that
the audio volume isn't correct, proceed
with the necessary adjustments as shown.
Use the included pan mechanism to adjust
the telecamera position.
LOCK RELEASE INSTALLATION
nstalling the FA-PLUS and FA-PLUS/C power supplies.
I
DIN 46277
f
3,5 x 25
DIN-7971
f
3,5 x 25
DIN-7971
If the lock release will be installed in a metal door, use a
Ø3,5mm. drill and tap the hole. In case of wood door,
use a
Ø3mm. drill.
IMPORTANT: the lock release to be used must be of 12Vd.c.
If you are using a.c. lock releases, use one R-3 relay unit and
one TF-104 transformer to activate it, as it is shown on page 19.
M 4 x 8
f
3,5 x 25
DIN-7972
DIN-963
DOOR PANEL INSTALLATION
POWER SUPPLY INSTALLATION
lace the nameplate labels.
P
lose the door panel.
C
Fix the door panel to the embedding box
by using the supplied vandal resistant screws
and the special screwdriver.
inal adjustments.
F
To install the power supply directly on the wall, drill two holes
of
Ø6mm. and insert the wallplugs.
Fix the transformer with the specified screws.
The power supply can be installed on a DIN 46277 guide
simply pressing it. To disassemble the power supply
from the DIN guide, use a plain screwdriver to lever
the flange as shown on the picture.
The FA-Plus/C model uses 6 units over DIN guide
and 10 units the FA-Plus model.
IMPORTANT: the maximum number of units that can be connected to a FA-Plus/C power
supply is 10, and 50 units in case of a FA-Plus model.
Link power supplies to connect more units than the specified as it's shown
on page 19.
The power supply must be installed in a dry and
protected place. It's recommended to protect
the power supply by using a thermo-magnetic
circuit breaker and to use a ground connection.
ock release installation.
L
