Customer Service Support: 1800 224 278 |
Page 17 of 24
10 Assembly Instructions (Jumping Mat & Net)
NOTE:
CHOKING HAZARD
- Small Parts. Not for children under 3 years.
ADULT ASSEMBLY REQUIRED
- Contains small parts, sharp points and sharp edges.
1. Preparing the trampoline mat. Unfold the Trampoline Mat (5). Have the Springs (6) and Spring Hook Tool
(7) ready for assembly.
2. Attach
ONLY 8 SPRINGS
(Using the spring
hook tool) to the V-rings to secure the jump
mat to the frame.
DO NOT ATTACH ALL THE SPRINGS TO
THE JUMP MAT AT THIS POINT
3. When connecting the Springs, always
connect the Springs opposite to each other to
get an even result in tensioning the Trampoline
Mat as shown in the below diagram.
4. Lay the safety net on the jumping mat,
spreading out the net. Ensure the net is fully
unraveled and not twisted.
Align the eyelets at the base of the
safety net, to the
8 springs
installed in
Steps 1 & 2.
It is important to double check that all the
eyelets align to a V Hook on the jumping mat
before proceeding with installation any further.
5. Undo the 8 installed springs one at a time.
Thread the spring through the eyelet at the
base of the safety net and through the V
Hook on the jumping mat.
Re attach the other end of the spring to the
frame using the Spring Hook Tool.
Follow the above instructions until all springs
are attached to the frame.
