Customer Service Support: 1800 224 278 |
Page 18 of 23
10 Assembly Instructions (Jumping Mat & Net)
NOTE:
CHOKING HAZARD
- Small Parts. Not for children under 3 years.
ADULT ASSEMBLY REQUIRED
- Contains small parts, sharp points and sharp edges.
1. Preparing the trampoline mat. Unfold the Trampoline Mat (5). Have the Springs (6) and Spring Hook Tool
(7) ready for assembly.
2. Attach
ONLY 8 SPRINGS
(Using the spring
hook tool) to the V-rings to secure the jump
mat to the frame.
DO NOT ATTACH ALL THE SPRINGS TO THE
JUMP MAT AT THIS POINT
3. When connecting the Springs, always connect
the Springs opposite to each other to get an
even result in tensioning the Trampoline Mat
as shown in the below diagram.
4. Lay the safety net on the jumping mat, spreading
out the net. Ensure the net is fully unraveled and
not twisted.
Align the eyelets at the base of the safety
net, to the
8 springs
installed in Steps 1 &
2.
It is important to double check that all the
eyelets align to a V Hook on the jumping
mat before proceeding with installation
any further.
5. Undo the 8 installed springs one at a time.
Thread the spring through the eyelet at the base of
the safety net and through the V Hook on the
jumping mat.
Re attach the other end of the spring to the frame
using the Spring Hook Tool.
Follow the above instructions until all springs are
attached to the frame.
