All contents copyright 2015, GOLDWING RC Version 1.0, Dec 2015
1.6
Cut the covering from the rudder servo slots from corner to corner and iron down inside
the openings. Connect servo wire extensions to your servos and secure the connections with
the supplied clips. Feed the servo wires into the fuselage. The screw holes for servo
mounting are laser pre-drilled, it is advisable to apply some thin CA to strengthen them, Install
the servos and screw firmly in place.
1.7
Use your radio to set the center of servo and then assemble and adjust the length of
the control rod. The servo arm should be as close to perpendicular to the control rod as
possible while the aileron is at neutral. Double check all screws, bolts and nuts to assure
proper installation and operation without binding. Once satisfied, permanently attach the ball
links to the servo arms and horns with the supplied screw and nut.
