1.
Aileron push rod linkage set. 3mmx61mm Pushrods for aileron.
2.
Locate the slots for the aileron control horn and remove the covering with a sharp knife. Place the
horns into position and the cover over the top to work out the area needing to be removed.
3.
Rough the area of the horn that will be glued in place.
4.
Using 30 minute epoxy glue the horn and plate into the aileron.
Summary of Contents for 91in CORVUS 50-60CC
