10
HOW TO TURN ON THE POWER
IMPORTANT: If the treadmill has been exposed to
cold temperatures, allow it to warm to room tem-
perature before turning on the power. If you do not
do this, you may damage the console displays or
other electrical components.
Plug in the power cord (see
page 8). Next, locate the
reset/off circuit breaker on
the treadmill frame near the
power cord. Switch the cir-
cuit breaker to the reset po-
sition.
IMPORTANT: The console features a display demo
mode, designed to be used if the treadmill is dis-
played in a store. If the displays light as soon as
you plug in the power cord and switch the reset/off
circuit breaker to the reset position, the demo
mode is turned on. To turn off the demo mode,
hold down the Stop button for a few seconds. If the
displays remain lit, see THE INFORMATION MODE
on page 13 to turn off the demo mode.
Next, stand on the foot rails of the treadmill. Find the
clip attached to the key (see the drawing on page 9)
and slide the clip onto the waistband of your clothes.
Then, insert the key into the console. After a moment,
the displays will light.
IMPORTANT: In an emergency
situation, the key can be pulled from the console,
causing the walking belt to slow to a stop. Test the
clip by carefully taking a few steps backward; if the
key is not pulled from the console, adjust the posi-
tion of the clip.
HOW TO USE THE MANUAL MODE
1. Insert the key into the console.
See HOW TO TURN ON THE POWER at the left.
The handlebars must be pivoted down and the con-
sole must be pivoted up before you use the tread-
mill (see page 7).
2. Select the manual mode.
When the key is inserted, the manual mode will be
selected. If a workout has been selected, remove
the key and then reinsert it.
3. Enter your weight if desired.
For the most accurate calorie count, enter your
weight into the console by pressing the Enter
Weight increase and decrease buttons repeatedly.
Note: Once you have entered your weight, your
weight will be saved in memory.
4. Start the walking belt.
To start the walking belt, press the Go button, the
Speed increase button, or one of the Quick MPH
buttons numbered 1 through 10.
If you press the Go button or the Speed increase
button, the walking belt will begin to move at 1 mph.
As you exercise, change the speed of the walking
belt as desired by pressing the Speed increase and
decrease buttons. Each time you press one of the
buttons, the speed setting will change by 0.1 mph; if
you hold down the button, the speed setting will
change in increments of 0.5 mph. Note: After you
press a button, it may take a moment for the walk-
ing belt to reach the selected speed setting.
If you press one of the numbered Quick MPH but-
tons, the walking belt will gradually change speed
until it reaches the selected speed setting.
To stop the walking belt, press the Stop button.
The time will begin to flash in the display. To restart
the walking belt, press the Go button or the Speed
increase button.
Reset
