Golden PR404-MED-SPC, Owner'S Manual

Page: 7 / 20

7
3. Place the chair in the desired
position in the room, keeping it 17"
away from the wall. If placing the
chair into a corner, keep it 17" from
the wall as shown. See distance
chart below for your model.
W
all
Side
View
Corner
Top
View
17"
17" 17"
Distance Required From Wall When Reclined
Model Number Wall Corner
4. Adjust the leg levelers on the bottom of the chair if necessary to level the chair.
Some high pile carpets can obstruct the footrest operation by rubbing against
it. Adjust the levelers to a height above the pile.
5. Slide the hand control from between the back and arm out toward the back of
the chair. Secure the cord into the quick release cable clamp located above the
magazine pocket on the arm of the chair.
Installation Of Your Golden Power Lift Chair
Model: PR404-MED-SPC
1. Remove the transformer from the transformer box (located behind the lower
outside back) and place two 9 volt batteries in transformer as shown. Place
transformer on the floor behind the chair.
2. Plug the transformer into a 115-120V 60Hz A.C. outlet and connect
the power cable from the chair into the transformer as shown. Power
cable is located under the chair attached to the motor with white zip
tie. Remove zip tie, extend the cable under and out behind the chair.
PR404-MED-SPC 17 in. 17 in.
L.E.D. light
L.E.D. light
From motor
To outlet
115-120V A.C.
DC Power
Bottom view of
Transformer
Transformer
Plug
Install two 9 volt batteries
in transformer for battery
backup (See page 10)
(batteries not included)
PA
TENTED