6
Installation Of Your Power Lift Chair
Model:
117
1. Remove the transformer from the transformer box (located behind the lower
outside back) and place two 9 volt batteries in transformer as shown. Place
transformer on the floor behind the chair.
2. Plug the transformer into a 115-120V 60Hz A.C. outlet and connect
the power cable from the chair into the transformer as shown. Power
cable is located under the chair attached to the motor with white zip
tie. Remove zip tie, extend the cable under and out behind the chair.
L.E.D. light
L.E.D. light
From motor
To outlet
115-120V A.C.
DC Power
Bottom view of
Transformer
Transformer
Plug
Install two 9 volt batteries
in transformer for battery
backup (See page 12)
(batteries not included)
PA
TENTED
3. Press the down arrow on the hand control until the
footrest is about parallel to the floor. This will expose
the back brackets at the rear of chair.
4. Slide the back down between the brackets until the
threaded studs on the back slip thru the holes in the
brackets as shown.
5. Thread the flange lock nuts, located in the arm cover
bag, onto the studs and tighten securely using the
supplied wrench or a 7/16" box wrench.
6. Return the chair to the seated upright position by
pressing the up arrow on the hand control.
7. Attach the bottom of the outside back to the Velcro on
the arm cross rail.
UP
DOWN
5
4
continued
