Alante Jr. GP-200 Manual
Revised 060208
DIAGNOSTICS/TROUBLESHOOTING Cont.
1.6
Slow or Sluggish Movement
If the wheelchair does not travel at full speed or does not respond quickly
enough, and the battery condition is good, check the maximum speed setting. If
adjusting the speed setting does not remedy the problem, then there may be a
non-hazardous fault. Contact your Golden Technologies representative.
1.7
Maximum Speed/Profile Indicator is Steady
The display will vary slightly depending on whether the control system is
programmed to operate with drive profiles.
1.7.1
Maximum Speed Indication
The number of LEDs illuminated shows the maximum speed setting. For
example, if the setting is speed level 4, then the four left hand LEDs will be
illuminated.
1.7.2
Profile Indication
The LED illuminated shows the selected drive profile. For example, if drive
profile 4 is selected, then the fourth LED from the left will be illuminated.
1.8
Maximum Speed/Profile Indicator Ripples Up and Down
This indicated the control system is locked.
1.9
Maximum Speed/Profile Indicator Flashes
This indicates the speed of the wheelchair is being limited for safety
reasons. The exact reason will depend on the type of wheelchair; however,
the most common cause is that the seat is in the elevated position.
The VR-2 modules are not user serviceable. Do not attempt to repair VR-2
modules.
Note that joystick OONAPU (
O
ut
O
f
N
eutral
A
t
P
ower
U
p) is not a fault. Simply by
removing your hand from the joystick and allowing it to return to the neutral position,
the fault will immediately clear. If the condition persists after removing your hand, the
joystick may be damaged. Consult a Golden Technologies representative.
