Golden Media Hypercube, User Manual

Page: 30 / 139

12.1.3 Two satellites via DiSEqC A/B (DVB-S2)
Use this type of configuration if you want to receive two satellites
from one Twin Universal or Quad Universal
LNB. It does not matter if you use one or two dishes to achieve
this.
In this case the LNBs are connected to a so-called Multi-switch
from which the signal is via coax cabled to the
satellite receivers (STB) in your household.
Please read the section 12.1 DVB-S/DVB-S2 configuration to
learn how to get into this menu.
The “Reception settings” menu will open up.
Use the up/down-Buttons to navigate to the “Mode” option and
use the left/right-Buttons to select “DiSEqC A/B”.
For Port A and Port B select the desired satellites just as
described in the Single satellite – direct connection section.
Make sure you know which satellite is connected to which input
on the Tone-burst switch. If you do not find any services in the
transponder scan later, exchange the two satellites in this list and
try again.
Press the OK-Button to save your settings.
If you have trouble with “Tune failed“ messages please set the
“Send DiSEqC only on satellite change“ and “Set voltage and
22KHz“ to “yes“.
12.1.4 Four satellites via DiSEqC A/B/C/D (DVB-S2)
Use this type of configuration if you want to receive four satellites
from one Single Universal or Twin Universal
LNB for four or eight parties. It does not matter if you use one or
two dishes to achieve this.
In this case the LNBs are connected to a so-called Multi-switch
from which the signal is via coax cabled to the
satellite receivers (STB) in your household.
Please read the section 12.1 DVB-S/DVB-S2 configuration to
learn how to get into this menu.
Four satellites via DiSEqC A/B/C/D (DVB-S) The Reception
settings menu will open up. Use the up/down-Buttons to navigate
to the Mode option and use the left/right-Buttons to select
DiSEqC A/B/C/D.
30