WW
W.
MD
ET
EC
TO
RS
.C
OM
WW
W.
MD
ET
EC
TO
RS
.C
OM
BANDITO-GOLDEN MASK
Bandito Impulse
5
very carefully into the last pipe. Fit
the cable of the coil to the coupling
“COIL” /turn it carefully till the
end/. After buying the detector you
have to charge it using the enclosed
charge device for few hours.
ATTENTION! You must not turn on
the detector if the coil is unfold,
otherwise you can damage it!
OPERATION
For reaching better results while
searching in deep soils, you have to
keep the following instructions:
Walk out away in a place where
there are no metal objects. Take up
the coil in the air, set the buttons
“POWER”, “GAIN”, “NOISE” and
“TRESHOLD” to
10
, and the button
“SIGNAL” to
0
. Put the coil close to
earth and set it still over 3-5 meters
over earth. Press the button “ZERO”
for about
2-3
seconds and release it.
The signal tone slowly disappears or
some occasional short tones can be
heard in the “SPEAKER”. Keep the
coil steady over the ground for some
minutes. If the signal tone or
occasional short tones appear again,
then slowly decrease to the left the
buttons
“POWER”
and
”TRESHOLD” while they can
hardly be heard. For the detector is
constructed for a wide range of
searching, to
find the proper
situation of an object we advise you
to set “SIGNAL” and “NOISE” on a
position
5
, where the signal tone will
be just over the object. It’s
reasonable to use the detector when
the situation of an object has been
localized before. You can also tune
up the apparatus to be very sensible
towards very small objects-nails,
caps, foil and other trash - so they
can’t be caught out by the detector.
Such discrimination is necessary
when digging huge range of soil for
finding great finds, not necessary
while searching spare coins. If soil
is highly mineralized you may her
different disturbances. You will
realize that if the signal of the
apparatus increases and do not
disappear in some meters. This
shows that under your feet there is a
huge object and signal comes by the
highly ore soil. So press the button
“FAST ZERO” for 2-3- seconds and
keep the coil steady over the ground.
Automatic
settings
will
make
operation with the detector normal
and you will be ready to continue
working in this region. If you use
