CAUTION: DURING THE INITIAL PURGING AND SUBSEQUENT
LIGHTING, NEVER ALLOW THE GAS VALVE CONTROL KNOB
TO REMAIN DEPRESSED IN THE A “PILOT” POSITION
WITHOUT PUSHING THE RED IGNITOR BUTTON AT LEAST
ONCE EVERY SECOND.
WARNING:
CHILDREN AND ADULTS SHOULD BE ALERTED
TO THE HAZARDS OF HIGH SURFACE TEMPERATURE AND
SHOULD STAY
AWAY TO AVOID BURNS OR CLOTHING
IGNITION. YOUNG CHILDREN SHOULD BE
CAREFULLY
SUPERVISED WHEN THEY ARE IN
THE SAME ROOM AS
THE APPLIANCE.
IMPORTANT: TURN OFF GAS BEFORE SERVICING
APPLIANCE. IT IS RECOMMENDED THAT A COMPETENT
SERVICE TECHNICIAN PERFORM THESE CHECKUPS AT
THE BEGINNING OF EACH HEATING SEASON.
WARNING: THE FLOW OF COMBUSTION AND VENTILATION
AIR MUST NOT BE OBSTRUCTED.
When lit for the first time, the appliance will emit a slight odor for
an hour or two. This is due to paint and lubricants used in the
manufacturing process. The main burner flame characteristics
are steady, not lifting or floating. Typically, the top 3/4 inch of the
pilot generator should be engulfed in the pilot flame. A periodic
check of these characteristics is necessary.
CAUTION: THE LOGS CAN GET VERY HOT! HANDLE ONLY WHEN COOL
MAINTENANCE INSTRUCTIONS
14
OPERATING GUIDELINES
Upon completing the gas line connection, a small
amount of air will be in the lines. When first lighting
the pilot light, it will take a few minutes for the
lines to purge themselves of this air. Once the
purging is complete, the pilot and burner will light
and operate as indicated in the instruction manual.
Subsequent lighting of the appliance will not require
such purging.
IMPORTANT:
THE APPLIANCE
AREA MUST BE KEPT CLEAR
AND FREE FROM COMBUSTIBLE
MATERIALS, GASOLINE AND
OTHER FLAMMABLE VAPORS
AND LIQUIDS.
Visually inspect pilot periodically.
Brush or blow away any dust or
lint accumulations. If pilot orifice
is plugged, disassembly may be
required to remove any foreign
material from orifice or tubing.
Venting system should be periodically
examined by a qualified service
technician or agency to ensure proper
air flow.
WIRING DIAGRAM
14
Summary of Contents for EL GRANDE
