Operating your Ceramic Heater
SUPPORT AND TECHNICAL ADVICE
PO Box 100707, NSMC, Auckland, New Zealand
Monday
– Friday 8am-5pm
Phone: 0800 232 633
Website: www.Goldair.co.nz
SAFETY DEVICE
This appliance has three protection devices:
The first device will automatically turn the appliance
off if the appliance is not in the appropriate operating
position.
The second device, automatically disconnects &
reconnects the appliance at a pre-set temperature.
The third device disconnects the appliance
permanently in case of overheating, by means of a
thermal fuse. (It is non resettable)
IMPORTANT! NEVER COVER THIS HEATER!
Covering the heater will cause activation of the non
resettable safety fuse.
CARE AND CLEANING
The heater requires regular cleaning to ensure
trouble free operation:
Unplug the heater from the mains supply before
cleaning.
Ensure that the heater has been allowed to cool
down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of
the heater to remove dust and dirt.
Never use solutions such as benzene, thinners or
polishing agents. In order to get the maximum heat,
the reflector must be kept clean.
Use a vacuum cleaner to remove dust and fluff from
around the grills.
Ensure the heater is dry before plugging back into
the mains supply.
Do not use this heater with a programmer, timer,
separate remote-control system or any other device
that switches the heater on automatically, since a
fire risk exists if the heater is covered or positioned
incorrectly.
WARNING Keep all objects at least 1 metre
from the front, sides and rear of the
appliance.
HEAT CONTROL SWITCH
The control switch positions are:
“0” = OFF
= Fan
“I” = Low Heat
“II” = High Heat
Check that the heat control switch is set to off
position before plugging the heater into the
mains supply. For greater economy, use the
high heat setting initially and then switch to
the low heat setting.
For the Low and High heat settings the fan
remains at the same settings, only the heating
block changes to create the greater/lesser
heat output.
THERMOSTAT
Turn the thermostat knob clockwise until the
maximum temperature is obtained on the
graduated
scale.
When
the
desired
temperature is reached, slowly turn the knob
anti-clockwise until the heater turns off (you
will hear a click). The temperature will now
remain constant, regulated by the thermostat.
PLEASE NOTE: THE FAN WILL CONTINUE
TO RUN EVEN THOUGH THE ELEMENTS
HAVE SWITCHED OFF, THIS IS NORMAL
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
