Goldair GSMH120 General Care And Safety Manual Download

Page: 4 / 6

Operating your Micathermic Heater

Always choose a safe location for the heater, keeping in mind the safety precautions

outlined. Ensure all packaging has been removed from the unit before use. This
appliance requires no installation, it should be used solely as a portable appliance.

SAFETY DEVICE
This appliance has two protection devices:
The  first  device  will  automatically  turn  the
appliance  off  if  the  appliance  is  not  in  the
appropriate operating position.
The  second  device  automatically  disconnects  &
reconnects  power  to  the  appliance  at  a  pre-set
temperature.

CAUTION: The heater generates heat during use.
Proper  precautions  must  be  taken  to  prevent  the
risk  of  burns,  scalds,  fires  or  other  damage  to
persons

CARE AND CLEANING
The  heater  requires  regular  cleaning  to  ensure
trouble free operation:
Unplug  the  heater  from  the  mains  supply  before
cleaning.
Ensure  that  the  heater  has  been  allowed  to  cool
down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of
the heater to remove dust and dirt.
Use  a  vacuum  cleaner  to  remove  dust  and  fluff
from around the grills.
Never use solutions such as benzene, thinners or
polishing agents.
Ensure the heater is dry before plugging back into
the mains supply.

Do not attempt to dismantle the heater. There are
no user serviceable parts.

PROOF OF PURCHASE
To  receive  warranty  retain  receipt  as  proof  of
purchase.
(Refer to back of booklet).

WARNING: THIS IS A DOUBLE SIDED HEATER.
Keep all objects at least 1 metre from the front,
sides and rear of the appliance.

WARNING: In order to avoid overheating, do

not cover the heater.

WARNING: Never leave this heater unattended.

WARNING: Do not use this heater with a

separate programmer, timer, remote-control

system or any other device that turns the unit

on automatically.

Note: When the heater is turned on for the first

time, it may release a slight, odour or smoke. This

odour or smoke is a normal occurrence caused by

the initial heating of the internal heating elements

and should not occur again.

CONTROLS
The control switch positions are:
O - Power Off

I – Power On

– Low Heat

– High Heat

Check that the On/Off switch is set to Off position
before plugging the heater into the mains supply.
For greater economy, use the High Heat setting
initially and then switch to the Low Heat setting.

THERMOSTAT
Turn  the  thermostat  knob  clockwise  until  you
reach the maximum temperature on the graduated
scale.    When  the  desired  room  temperature  is
reached,  slowly  turn  the  knob  anti-clockwise  until
the  heater  turns  off  (you  will  hear  a  click).  The
heater will now cycle on and off to maintain the set
temperature. Take note of this temperature setting
for future use.