Operating your Convector Heater
•
SAFETY DEVICE
•
This appliance has two protection devices: The first
device automatically disconnects & reconnects the
appliance at a pre-set temperature.
•
The second device disconnects the appliance
permanently in case of overheating, by means of a
thermal fuse (it is non resettable).
IMPORTANT! NEVER COVER THIS HEATER!
CARE AND CLEANING
The heater requires regular cleaning to ensure
trouble free operation:
Unplug the heater from the mains supply before
cleaning.
Ensure that the heater has been allowed to cool
down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of
the heater to remove dust and dirt.
Never use solutions such as benzene, thinners or
polishing agents.
Use a vacuum cleaner to remove dust and fluff from
around the grills.
Ensure the heater is dry before plugging back into
the mains supply.
Do not attempt to dismantle the heater. There are
no user serviceable parts. For service or repair,
contact an authorised electrical service technician.
CAUTION: The heater generates heat during use.
Proper precautions must be taken to prevent the risk
of burns, scalds, fires or other damage to persons
Do not use this heater with a programmer, timer,
separate remote-control system or any other device
that switches the heater on automatically, since a
fire risk exists if the heater is covered or positioned
incorrectly.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
WARNING Keep all objects at least 1 metre
from the front, sides and rear of the appliance.
ASSEMBLY OF THE HEATER
Each foot supplied with this heater (supplied
separately in the carton) requires only 2 screws to
attach them securely to the heater. Holes are pre-
drilled in the base of the heater.
The screw pack to attach the feet to your heater
will be taped to either one of the feet for your
heater, or taped to the plug head.
TIP: Slightly angle the screws into the holes when
you insert them. As you tighten them up, they will
straighten and secure the feet.
The foot comes with 4 pre-drilled holes. It does
not matter which way round you mount them.
HEAT CONTROL SWITCH
The control switch positions are:
“750W”
Low heat
“1250W”
Medium heat
“2000W”
High Heat (Press 750W & 1250W
switches together)
Check that the On/Off switch is set to Off position
before plugging the heater into the mains supply.
For greater economy, use the High Heat setting
initially and then switch to the Lower Heat
settings.
THERMOSTAT
Turn the thermostat knob clockwise until you
reach
the
maximum
temperature
on
the
graduated scale. When the desired room
temperature is reached, slowly turn the knob anti-
clockwise until the heater turns off (you will hear a
click). The heater will now cycle on and off to
maintain the set temperature.
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
Goldair Select
– New Zealand
Monday
– Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
[email protected]
Goldair Select
– Australia
Monday
– Friday 8am-5pm
Phone +61 (0)3 9336 4423
Phone 1300 465 324
SUPPORT AND TECHNICAL ADVICE
