background image

OPERATING YOUR HEATER

Place the product in an upright position on a flat, steady, stable, heat-resistant surface. Make sure there is 

nothing flammable or heat sensitive within 1 meter (40 inches). Operating the product in any other 
position could cause a hazard.

Insert the plug into a suitable wall outlet after turning the thermostat knob counter-clockwise to the minimum 

position and setting the power switch to “0” for off. The heater is suitable for operation on an A.C. 
electricity supply having the same voltage as that show on its rating label.

Heat Setting Operation

Turn the power switch from “0” to either “●” (Minimum heating), “●●” (Medium heating) or “●●●” (Maximum 

heating).

Turn the thermostat knob clockwise to maximum position. When the room temperature rises to a  

comfortable level, slowly turn thermostat counter-clockwise until the indicator light just goes out. 

To adjust the room temperature turn the thermostat clockwise to raise the temperature, or counter-clockwise 

to lower it. Thus the heater will attempt to keep the room temperature at the desired level.  

To turn off the heater, turn the power switch to “0” position. The power indicator light turns off. Unplug the 

product from the electrical outlet when it is left unattended or is not in use.  

Timer Setting Operation

24-hour timer. Each segment is 15 minutes
First, set the current time by rotating the Timer Dial clockwise until the arrow points to the correct time.
Next, set the time at which you want the heater to turn ON, by pushing the relevant sections outwards 

(towards the outside of the dial).

For all other times, when you want the heater to be off, make sure the corresponding sections are pushed 

inwards (towards the centre of the dial).

TURBO/CERAMIC HEATER

The turbo function is for supplying heat instantly whilst the main heater warms up. For turbo heat,
switch the Turbo ON/OFF using the switch on the front of the turbo cover. Turbo function is also
governed by the thermostat and timer/mode settings.

FULL SIZE OIL COLUMN SPECIFICATION

Model No: GOC1411TH
Power Supply: 230-240V, 50Hz AC only
Power: 2400W

PROOF OF PURCHASE

To receive warranty retain receipt as proof of purchase. (Refer to back of booklet).

Summary of Contents for GOC1411TH







Reviews: