Operating your Micathermic Heater
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
CARE AND CLEANING
The heater requires regular cleaning to ensure trouble
free operation:
Unplug the heater from the mains supply before
cleaning.
Ensure that the heater has been allowed to cool down
completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of the
heater to remove dust and dirt.
Never use solutions such as benzene, thinners or
polishing agents. In order to get the maximum heat,
the reflector must be kept clean.
Use a vacuum cleaner to remove dust and fluff from
around the grills.
Ensure the heater is dry before plugging back into the
mains supply.
Do not attempt to dismantle the Micathermic Heater.
There are no user serviceable parts. For service or
repair,
contact
an
authorised
electrical
service
technician.
CAUTION
The Micathermic Heater generates heat during use.
Proper precautions must be taken to prevent the risk
of burns, scalds, fires or other damage to persons.
WARNING:
Do
not
use
this
heater
with
a
programmer, remote-control system, separate timer
or any other device that switches the heater on
automatically.
IMPORTANT! NEVER COVER THIS HEATER!
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
WARNING: THIS IS A DOUBLE SIDED HEATER.
Keep all objects at least 1 metre from the front, sides
and rear of the appliance.
Note: When the heater is turned on for the first time, it
may release a slight, odour or smoke. This odour or
smoke is a normal occurrence caused by the initial
heating of the internal heating elements and should
not occur again.
HEAT CONTROL SWITCH
The control switch positions are:
I
Low Heat
II
High Heat (both switches on)
Check that the heat control switch is set to Off position
before plugging the heater into the mains supply. For
greater economy, use the High Heat setting initially
and then switch to the Low Heat setting.
THERMOSTAT
Turn the thermostat knob clockwise until you reach
the maximum temperature on the graduated scale.
When the desired room temperature is reached,
slowly turn the knob anti-clockwise until the heater
turns off (you will hear a click). The heater will now
cycle on and off to maintain the set temperature.
SAFETY DEVICE
This appliance has two protection devices. The first
device automatically disconnects & reconnects the
appliance at a pre-set temperature.
The
second
device
disconnects
the
appliance
permanently in case of overheating, by means of a
thermal fuse (it is non resettable).
Goldair
– New Zealand
Monday
– Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
[email protected]
Goldair
– Australia
Monday
– Friday 8am-5pm
Phone +61 (0)3 9336 4423
Phone 1300 465 324
SUPPORT AND TECHNICAL ADVICE