STEAM IRONING
•
Place the iron in a vertical position and set the temperature control dial at the
minimum/low heat setting.
•
Insert the plug into the socket, and then turn the temperature control dial to the
“high heat” marking. The pilot light will come on, indicating that the iron is
heating up.
•
When the pilot light turns off, the set temperature has been reached and the iron
is ready to use.
•
During ironing, the pilot light on the iron automatically switches on/off as the
thermostat maintains the set temperature (you may continue ironing during this
process).
•
Turn the steam dial to the required position.
•
Steam is produced as soon as the iron is held horizontally.
SPRAYING
Press the spray button to spray water on your garment, as often as required.
Note: When using the water spray function, ensure that there is enough water in
the water tank.
Note: You may have to pump the spray button several times at first use.
BURST OR VERTICAL STEAM IRONING
Press the burst of steam button to generate a powerful burst of steam that can
penetrate the fabric and smooth the most difficult, tough creases. Wait for a few
seconds before pressing again.
By pressing the burst of steam button at intervals you can also iron vertically (i.e.
curtains and hanging garments).
Note: The burst of steam function can only be used at high temperature. Stop the
emission when the pilot light turns on. Start ironing again only after the pilot light
has turned off.
DRY IRONING
For ironing without steam, follow the instructions in the section “steam ironing”,
however, the steam control turning switch should be set to the “0” position. (no
steam).
Fabric
Temperature Control
Temperature Requirement
Synthetic
Low Temperature
Silk, Wool
Medium Temperature
Cotton, Linen
High Temperature