Operating Instructions (Continued)
OPERATION
1. Ensure that the water container is positioned correctly.
2. Plug into power supply, 3 beep signals will be heard.
3. Press the Power button the unit will automatically start to dehumidify.
-The blue backlight will illuminate and turn off after 15 seconds
-The LCD display will show the working mode and status of unit
-The LCD display shows the ambient humidity and temperature
-
Press the “ON/OFF” button again, the unit will stop
4. Choose the desired dehumidification mode (continuous or automatic) and fan speed.
-
To choose the continuous dehumidifying mode, press the MODE button until the “continuous
dehumidifying” flashes on the electronic display. Then press the SETTING button to confirm your selection.
In this mode the dehumidifier will run continuously until turned off.
- Within the continuous dehumidifying mode you can also set the desired fan speed. To do this,
press the MODE button until the “Wind Speed” flashes on the electronic display. Once it is
flashing press the SETTING button to change the fan speed.
-
To choose the automatic mode, press the mode button until the “Automatic dehumidifying” flashes on the
electronic display. Then press the SETTING button to confirm your selection.
- Press the SETTING button multiple times to change the desired relative humidity level in the
automatic mode
NOTE: When the sensor detects an ambient humidity level 1% lower than the set level the compressor will
turn off and the fan will continue to run. Once the ambient humidity level drops 5% below the set level the
compressor will turn back on and continue to dehumidify.
5. If you would like to set the 24 hour timer you can do so by using the TIMER button (Each press of the
button will increase the time set by 1 hour). There are two options when using the timer function
-When the dehumidifier is running, you can set the timer to turn off the unit after X amount of hours. In order
to do this, whilst the dehumidifier is running press the TIMER button until the desired length of time is
displayed on electronic display
-When the unit is off you can set the timer to turn the dehumidifier on after X amount of hours. In order to do
this, whilst the dehumidifier is off (but still plugged into a power outlet) press the TIMER button until the
desired length of time is displayed on electronic display
When the dehumidifier water tank is full a 10 beep signal will sound and the “Water Full” will flash on the
electronic display.
DEFROST
When the dehumidifier is operating in low temperatures the unit will go into a defrost cycle. This is to
remove any ice that has accumulated on the interior of the unit as a result of its operation. How often the
dehumidifier goes into its defrost cycle will depend on the temperature and humidity in the room.
