Operating your Ceramic Tower Heater
Always choose a safe location for the heater, keeping in mind the safety
precautions outlined. Ensure all packaging has been removed from the
unit before use. This appliance requires no installation, it should be used
solely as a portable appliance.
TIMER
The timer function allows you to set the length of
operation time before the unit shuts off and can be
operated in any mode.
Delayed Switch On:
When the appliance is off, press the timer button,
the timer icon will display in the control panel and
the amount of time remaining before the unit
switches on will be displayed.
To adjust the length of time, use the “+” and “–”
buttons, then wait a few seconds for the
programming to be set.
When the programmed time has been reached, the
appliance turns on with the same settings it had
during the previous operation.
Delayed Switch Off:
When the appliance is on, press the timer button,
the timer icon will display in the control panel and
the amount of time remaining before the unit
switches off will be displayed.
To adjust the length of time, use the
“+” and “–”
buttons, then wait a few seconds for the
programming to be set.
The control panel will return to display the current
settings and the symbol to indicate you have set the
timer. When the programmed time as been reached
the appliance shuts off automatically.
If you want to go back to operation without the timer,
press the timer button twice. The timer symbol
disappears from the display
NOTE: The display can show the temperature in
both °F and °C. To change the temperature scale,
press and hold the “+””-“ key for 3 seconds, then
release.
Please be informed that as this is not a precision
device, the shown temperature does not necessary
corresponds to the real one.
USING THE REMOTE CONTROL
The remote control functions correspond to those on
the control panel.
INSERTING OR REPLACING THE BATTERIES
Remove the cover on the rear of the remote control.
Replace battery with model: CR/2032/3V into
remote control.
Replace the cover.
OPERATE
Plug the unit into the mains supply and switch on
mains, the unit will beep three times and the blue
indicator lights on the control panel will illuminate
indicating there is power to the unit.
To operate the unit, press the “On/Off” button. The
unit will begin to heat with predefined settings.
Press Mode button once for
low fan heat
Press the Mode button twice for
high fan heat
In Low heat and High heat you can adjust your
desired temperature by pressing the “+” and “-”
buttons.
Press the Mode button three times for Eco Mode.
In this operating mode the appliance will
automatically set the power level (reducing the
energy consumption). In this operating mode the
unit may switch the heating power level from
maximum to minimum and vice versa, several
times in an hour. When using the ECO function,
the maximum temperature setting is 26°C.
Press the Mode button four times for use of the
fan only; In this mode the fan blows temperature
air, so does not heat the room.
Press the Mode button five times for use of the
Antifreeze; In this Mode the unit keeps the room
at a temperature of 7 degrees to prevent freezing
temperatures. This is a preset temperature and
cannot be changed.
OSCILLATE
This button turns the heater oscillation function on
and off.
How the set temperature is maintained:
If the room temperature is higher than the set
temperature, the heater switches itself off.
If the room temperature is lower than the set
temperature, the heater automatically switches
itself back on again.
