OVERVIEW OF GOLDAIR COOLING FAN
Your Goldair Cooling Fan is designed to provide direct personal cooling. The fan is equipped with three
speed settings to ensure your precise cooling needs are met.
OPERATING YOUR COOLING FAN
Always choose a safe location for the fan, keeping in mind the safety precautions outlined. Ensure all
packaging has been removed from the unit before use. This appliance requires some assembly it should be
used solely as a portable appliance.
ASSEMBLING YOUR COOLING FAN
ASSEMBLY OF BASE
Firstly, loosen and remove the four screws from the bars. Then cross bar A and bar B so that they interlock.
Be sure to align the four holes in the bars with those on the flange of the Outer Tube. Secure the flange to
the bars with the four screws.
Loosen and remove the Height Adjustment Collar from the top of the Inner Tube. Slide the Base Decorative
Cap down over the assembly. Replace the Height Adjustment Collar on top of the Inner Tube. Pull the
Inner Tube out from the Outer Tube to adjust the tube to the desired height and tighten the collar.
If necessary, slightly loosen the Set Screw by turning it anticlockwise. Slide the Switch Box down over the
Inner Tube and tighten the Set Screw. Make sure the Set Screw is tightly secured.
ASSEMBLY OF BLADE AND GRILL
Unscrew the plastic mounting nut from the front of the motor housing by rotating it anticlockwise.
Position the rear grille against the front of the motor housing with the handle uppermost, ensuing that the
locating pegs on the motor housing are engaged correctly in the holes of the rear grill.
Tighten the Rear Grill Mounting Nut clockwise.
DO NOT OVERTIGHTEN IT
.
Push the fan blade onto the motor shaft, locating the slot at the back of the blade on the drive pin that
passes through the motor shaft. Tighten the blade cap by turning it anticlockwise.
Position the front grill against the rear grill so that the holes in the rims that accept the small nut and bolt
are in line. Insert the bolt through the holes and screw on the nut. Do not fully tighten at the stage.
Push the grill retaining clips into position ensuring that they engage correctly on the rim of the grill.
Fully tighten the small nut and bolt that passes through the rim of the grill.
POWER CONTROL SWITCH
The control switch positions are:
• 0 = OFF
• 1 = Low Speed
• 2 = Medium Speed
• 3 = High Speed
Check that the control switch is set to off position before plugging the fan into the mains supply.
To activate the oscillation function, push down the oscillation pin (7) on the top of the motor. The fan will
then oscillate until the pin is pulled back up.
