Assembly
Step 1
- Unscrew the Base Locking Screw
and Ring from the stand Pole and insert
the stand Pole through the hole in the
centre of the Base. Tighten the Base and
Pole by twisting into position.
Turn the Base upside down with the pole
facing the floor then place the Base Weight
Support at the bottom of the Stand Base.
Tighten the Base Weight Support to the
Stand Base with the Ring and Base
Locking Screw.
Step 2
- Unscrew the Tilt Lock Nut from
the Motor Unit. Put the Motor Unit into the
Pole, reinsert and tighten the Tilt Lock Nut
The moulded base surround is supplied
with 3 retaining screws (in a small bag
taped to the inside of the surround).
Remove the bag containing the screws and
position the surround on the moulded
retaining clips on the base and snap into
place. Ensure that the surround has
clipped firmly into position onto the fan
base and screw the 3 retaining screws into
the holes across the middle of the base.
Do not over-tighten these screws.
Step 3
- Take off Guard Lock Nut from
motor shaft. Place the Rear Guard on the
front of the motor housing. Line up the lugs
on the front of the motor housing with the
holes in the rear guard. Screw on Guard
Lock Nut tightly to attach rear guard.
Place the fan Blade on the motor shaft and
secure it by tightening the fan blade nut.
Fit the Front Guard onto the rear guard and
close the clips, then secure the grill with
the small screw provided.
Components
