WARNING Keep all objects at least 1 metre from
the front, sides and rear of the appliance.
Note: When the heater is turned on for the first
time, it may release a slight, odour or smoke. This
odour or smoke is a normal occurrence caused by
the initial heating of the internal heating elements
and should not occur again.
HEAT CONTROL SWITCH
The control switch positions are:
OFF
Off
FAN
Fan only
LOW
Low Heat
HIGH
High Heat
FAN
Fan only with Oscillation
LOW
Low Heat with Oscillation
HIGH
High Heat with Oscillation
Check that the heat control switch is set to Off
position before plugging the heater into the mains
supply. For greater economy, use the High Heat
setting initially and then switch to the Low Heat
setting. For the Low and High Heat settings the fan
remains at the same speed, only the element
changes to create the greater/lesser heat output.
THERMOSTAT
Turn the thermostat knob clockwise until you reach
the maximum temperature on the graduated scale.
When the desired room temperature is reached,
slowly turn the knob anti-clockwise until the heater
turns off (you will hear a click). The heater will now
cycle on and off to maintain the set temperature.
CAUTION: The heater generates heat during use.
Proper precautions must be taken to prevent the
risk of burns, scalds, fires or other damage to
persons
Always choose a safe location for the heater, keeping in mind the safety precautions
outlined. Ensure all packaging has been removed from the unit before use. This
appliance requires no installation, it should be used solely as a portable appliance.
SAFETY DEVICES
This appliance has three protection devices:
The first device will automatically turn the appliance
off if the appliance is not in the appropriate
operating position.
The second device automatically disconnects &
reconnects the appliance at a pre-set temperature.
The
third
device
disconnects
the
appliance
permanently in case of overheating, by means of a
thermal fuse. (It is non resettable).
Do not attempt to dismantle the heater. There are
no user serviceable parts. For service or repair,
contact an authorised electrical service technician.
IMPORTANT! NEVER COVER THIS HEATER!
CARE AND CLEANING
The heater requires regular cleaning to ensure
trouble free operation.
Unplug the heater from the mains supply before
cleaning.
Ensure that the heater has been allowed to cool
down completely before cleaning.
Use a damp cloth (not wet) to wipe the exterior of
the heater to remove dust and dirt.
Never use solutions such as benzene, thinners or
polishing agents.
Use a vacuum cleaner to remove dust and fluff
from around the grills.
Ensure the heater is dry before plugging back into
the mains supply.
Do not use this heater with a programmer, timer,
separate remote-control system or any other device
that switches the heater on automatically.
PROOF OF PURCHASE
To receive warranty retain receipt as proof of
purchase. (Refer to back of booklet).
Goldair
– New Zealand
Monday
– Friday 8am-5pm
Phone +64 (0)9 917 4000
Phone 0800 232 633
[email protected]
Goldair
– Australia
Monday
– Friday 8am-5pm
Phone +61 (0)3 9336 4423
Phone 1300 465 324
SUPPORT AND TECHNICAL ADVICE
General Care and Safety Guide
