Loosen the Adjusting Screw by turning it anti-
clockwise until it totally comes out of the M6
Screw Nut.
Place the extension under the motor unit into
the slot of the Base
Align the two connecting pieces such that
their holes are in line.
Penetrate the Adjusting Screw through the
holes of the two connecting pieces
Fasten by turning the Adjusting Screw
clockwise.
CAUTION:
When placing a fan on a table or shelf, always
ensure that the power cord does not hang
where it can accidentally be pulled and that
the unit cannot accidentally fall.
Do not hang or mount the fan on a wall or
ceiling.
1. On / Off and Speed Control
The ON/OFF and Speed is controlled by the
Turning Switch, which is located on the rear
motor housing indicated in the above
diagram.
0 - The Fan is switched Off
1 - The Fan operates at the lowest speed
2 - The Fan operates at the highest speed
2. Angle Adjustment
Switch off the fan. Slightly loosen the
Adjusting Screw by turning it anti-clockwise.
Adjust the fan to the desired angle and then
tighten the Adjusting Screw by turning it
clockwise.
Assembly
Operating your Fan
