Goldacres G6 Crop Cruiser 2 Series, Software Update

Page: 10 / 22

10 GA8701177 REV 2 SUPPLEMENT SEPT 2022
G6 Crop Cruiser Series 2 Operators Manual - Software Update Supplement
G-Hub Settings
Various screens have changes and/or new
screen added in the software update for the
G-Hub controller:
• Display
• Machine/Setup
• Machine/Boom Automation
• Settings/Machine/Steering Diagnostics
• Machine/Steering Calibration
• Plumbing/Boom Sections
• Plumbing/Tank Levels
• Plumbing/Tank Levels
• Hydraulics
• Engine/Engine
• Engine/Transmission
• Engine/Cruise
• Engine/Faults
• Diagnostics/Nework
• Diagnostics/G-Motion
• Diagnostics/Console
• Diagnostics/Boom I/O
• Diagnostics/PLC I/O Input
• Diagnostics/PLC I/O Ouput
• Service/Hardware
• Service/Software
• Service/Active Faults
• Service/Fault History
Display
The updated Display screen includes the
addition of:
• ‘Help (?)’ touch button in the lower left
hand corner of the screen
Press the ‘Help (?)’ touch button & a
help information screen appears
• ‘Auto Brightness’ touch button
Press the touch button to choose On
or Off - displays Green when On &
Grey when Off.
The updated software provides a ‘Help (?)’ touch button
on each screen where operator settings are required.
Press the ‘X’ touch button to close the close the screen.
Screens providing machine operating information only do
not have a ‘Help (?)’ touch button.
Updated G-Hub Display screen showing the ‘Help (?)’ & ‘Auto Brightness’ touch buttons (refer G6 Crop Cruiser Series 2
Manual page 74).
Setting the ‘Return to Level’
Position
To Set the ‘Level’ Position:
1 Move the boom to desired position.
2 Press and hold ‘Cruise Master’ push
button.
3 While holding the ‘Cruise Master’ push
button, press ‘Boom Lower’ push button
to set the position, then release both push
buttons.
The Headland Assist set up is now complete.
After the ‘Headland Assist’ & ‘Return to Level’
positions are set, the sensor values will be
displayed on the ‘Headland Assist’ settings
screen after a power cycle (Off & On).
Sensor values range from 4000 to 20000.
Operating ‘Headland Assist’
Double press ‘Dual Tilt Up’ push button to
move the boom to the ‘Headland’ position
Double press ‘Dual Tilt Down’ push button to
move the boom to ‘Field’ position
Double press ‘Boom Lift’ or ‘Boom Lower’
push buttons to ‘Return to Level’ position.
Press & hold the ‘Boom Master’ push button, then press the
‘Tilt Up’ push button to move the boom to ‘Headland’ position.
Press & hold the ‘Boom Master’ push button, then press the
‘Boom Lower’ push button to set the ‘Return to Level’ position.
Double press the Boom Lift or Boom Lower push buttons
to ‘Return to Level’ position.