background image

                                                                                                                   Sno-Konette 

All Models #1002S, #1003S  

3

Installation Instructions 

 

Inspection of Shipment: 

 

Unpack all cartons and check thoroughly for any damage that may have occurred during 
transit. Damage claims should be filed immediately with the transportation company. Gold 
Medal Products is not responsible for damage that occurs in transit. 

 

Setup: 

 

Your new Sno-Konette was assembled and tested at the factory.   
Remove all packing material and tape before starting operation. 

 

     

Electrical Requirements: 

 

The following power supply must be provided: 

 
           120 Volt, 15 Amp, single phase, 60 cycle AC current 
 
 

 
 

 
 
 

 
 

 

Your electrician must furnish sufficient power for proper machine operation. We recommend 
this machine be on a dedicated and protected circuit.  Failure to wire properly will void the 
warranty and may result in damage to the machine. 

 

It is Gold Medal Products Company’s recommendation that this machine be plugged directly 
into a wall outlet.  The use of extension cords is not recommended due to safety concerns, 
and may cause sacrificed and/or reduced performance. 
 

    

Before You Plug In Machine:

 

 

1. Make sure that the wall outlet can accept the three (3) prong grounded plug on the power 

supply cord. 

 
2. The wall outlet must have the proper polarity. If in doubt, have a competent electrician 

inspect the outlet and correct if necessary. 

 

           3. 

DO NOT

 use a three (3) prong grounded to two (2) prong un-grounded adapter 

 

 
 

Reviews: