Shav-A-Doo
Model Series: 1203
Page 11
gmpopcorn.com
14.
Adjust the motor to realign with guide mark made on the cabinet in Step 3, then
refasten motor mounting bolts (if unit has a hopper support and guide, it must
also be reinstalled). Check the shaver head to make sure it is not rubbing against
the back of the hopper and the blades are not touching the pusher handle or sides
of hopper; adjust as needed.
NOTE:
Replace any shims that were between the motor base and the mounting surface.
15.
Reinstall motor cover.
With a permanent marker, mark
shaft where shaver head stops.
Shaver Head
(2) Set Screws (fasten on
flat side of motor shaft)
With a permanent marker, mark
cabinet where motor sets.
Motor
Mounting
Bolts
Height Gauge 1/32”
(0.8 mm)
(thickness of a dime)
Set top of blade flush with
height gauge, as shown.
Blade Mounting Screw
Shaver Blade
Shaver Head
Cut Away View of Shaver Head on Motor Shaft
General shaver image shown for reference only (models may vary).
Set Blade Height