Macho Pop
Model No. 2553 Series and 2554 Series
Page 19
gmpopcorn.com
4.
Audio Volume
- The audible signal to dump is preset at the factory to level 8, valid
range is 0 (off) to 10 (full volume).
5.
Voltage Slope
–
This is factory set to zero (0),
DO NOT adjust.
6.
Loop Break
–
This is factory set to zero (0),
DO NOT adjust.
7.
Auto Shut Off
–
The default factory setting is OFF. To change this setting, scroll
through the parameters until Loop Break is active, then press the “DOWN arrow again
to view the Auto Shut Off parameter (the 3 Character LED D
isplay will read “Aof” if the
Auto
shut Off is disabled, and it will display “Aon” if it
is enabled).
When this feature is enabled, the Auto Shut Off will automatically turn the kettle heat
off after 15 minutes of idle time (no popcorn popped). This feature saves electrical
power and extends the life of the kettle heating element and thermocouples, since it
will not cycle off-on when the kettle heat switch is left on.
1.
When the kettle heat switch is turned ON, and the thermocouple reaches set
point, the Auto Shut Off 15 minute timer starts; the 15 minute timer resets each
time a batch of popcorn is popped.
2.
The Dump Light on the control panel will blink OFF-ON once per second (if
Audio Volume is on the unit will also beep) to indicate the kettle has been
automatically turned OFF.
3.
To restart the kettle heating, cycle the kettle heat switch OFF-ON.
Programming the Electronic Control
The settings for the Kettle Dump, Audio Volume, and Auto Shut Off parameters may be adjusted
if needed. Follow the steps on next page to select the parameter to be adjusted, to put it into
programming mode, and adjust the setting.
Note:
Units with Salt/Sweet capability must be in the appropriate mode to adjust settings
for that mode. When in the Sweet mode, the Sweet parameter light (see image
below) will be ON steady. If the Sweet light is NOT on, the unit is in the Salt mode.
Select Button
“UP” Arrow
“DOWN” Arrow
3 Character
LED Display
Sweet Mode
–
Unit is in Sweet Mode when this LED
light is ON. For Salt Mode this LED will be OFF.
Parameters
with LED
indicators