Food Holding Cabinet
Model No. 5587-00-190
Page 11
gmpopcorn.com
ORDERING SPARE PARTS
1.
Identify the needed part by checking it against the photos, illustrations, and/or
parts list. (General images may be used in manual for reference only.)
2.
Use only approved replacement parts when servicing this unit.
3.
When ordering, please include part number, part name, and quantity needed.
4.
Please include your model number, serial number, and date of manufacture (located
on the machine nameplate/data plate) with your order.
5.
Address all parts orders to Parts Department, Gold Medal Products Co., 10700
Medallion Drive, Cincinnati, Ohio 45241-4807
or place orders by phone or online:
Phone: (800) 543-0862
(513) 769-7676
Fax: (800) 542-1496
(513) 769-8500
E-mail: [email protected]
Web Page: gmpopcorn.com
Replacing Broken Glass
Broken glass panels can be easily replaced. Gold Medal
Products Co. does not ship glass. It can be
obtained from a local glass shop, always purchase tempered glass.
GLASS DIMENSIONS
(Height x Width x Thickness)
Front Glass:
16 1/2
” x 10 59/64” x 1/8
Side Glass:
16 1/2
” x
13 5/8
” x 1/8 (
2 pieces per unit)
1.
Turn machine OFF, unplug unit and allow it to cool before attempting to replace glass.
2.
Remove all loose pieces of glass.
3.
Place a bungee (or large rubber band) around the unit to help hold the corner posts in
place, then remove dome and sign.
4.
Remove all rigid glass channels from around glass to be replaced, set channels aside
for reuse.
Note:
The rigid channels may be wedged in the corner posts or top and bottom glass
extrusions, and must be removed before new glass can be installed.
5.
Carefully remove the rest of the broken glass.
6.
Apply decals (if desired) to new glass panel.
7.
Slide rigid glass channels over exposed sides and bottom of new glass panel.
8.
Lift motor plate (ceiling plate) out of the way to allow the new glass panel to slide into
the corner posts and down into the bottom glass extrusion.
9.
Make sure the rack holders are still in place, then carefully lower the motor plate until
the top glass extrusion secures glass in place.
10.
Reinstall dome and sign, then remove bungee.
