SmartBox
®
4 / SmartBox
®
4
PRO
part no. 28 400 57 c
23 / 32
Alarm
The status of the alarm input (DIGITAL INPUT) is reported in plain text, e.g.:
•
kein Alarm (no alarm)
•
Alarm 1 Anlagenstörung
the text Anlagenstoerung (Facility failure)
can be changed (Command #A1)
•
Alarm 1 OK
OK report, i.e. alarm 1 has been cancelled
•
Alarm Tank n
Tank display device n reports a fault or an
alarm
•
Alarm Tank n OK
OK report; i.e. the fault/alarm has been
cancelled
•
Temp-Alarm n
Tank n has fallen below the set temperature
•
Temp-Alarm n OK
OK report; i.e. the temp alarm from tank n has
been cancelled
Credit or
SMS
counter
The credit remaining on a prepaid card is indicated if the service provider
allows this function (USSD process). In Germany this is possible in the T-
Mobile, Vodafone and O
2
networks. For contract cards, this function makes
no sense; for them, an SMS counter should be activated, see #G=.
Relais
Rel=0
Relay OFF ; Rel=1
Relay ON
only SmartBox
®
4
Error
Command error: - The SMS only shows this element if an error is pending -
The SmartBox has received a command that is invalid and cannot be
processed. Check the format of command
see List of commands
Example
message
Ct-024 Tankmonit. K. Miller, Levenham Rd.21; Tank filling 2;
33%=1600L, 40%=40.00, 100%=99.99; no alarm; 14.81 £, Rel=0
LIST OF COMMANDS
The commands to the SmartBox are sent automatically if the
www.smart-inspector.com
system is used. Alternatively, they can be sent manually via SMS from a mobile phone.
All commands start with the # character (command character).
Comm-
and
Parameter
Description
Standard /
default value
#T=
Mobile network
number for the
SMS messages
Mobile phone number
to which the
automatically generated reporting SMS are sent
(e.g. building supervisor, headquarters)
#TA1=
(identica
l to
#TA=)
1. Mobile phone
number for
alarms
1. Mobile phone number
for a fault mobile
phone. If for
#TA1
=... an alarm number is
entered, the alarm SMS is sent to this number
(approx. 5-minute delay).
If no number is entered (field empty), the report
is sent to the
#T
number.
If Smart-
Inspector
connection
exists, this
field is empty
#TA2=
…
#TA3=
2. + 3. Mobile
phone number
for alarms
2. + 3. Mobile phone number
for a fault mobile
phone. The current alarm is reported to this
number as 2. / 3. (for delay time, see command
#Q
= ) If this alarm number is not entered
(empty), this means that the end of the alarm
chain has been reached and that there are no
further messages for this alarm.
If Smart-
Inspector
connection
exists, this
field is empty
#Q=
Change the delay time for the alarm chain, e.g.
#Q
=10 sets the delay time to 10 minutes.
20
[1…255]
