EN - 20
IMPORTANT NOTES
INTRODUCTION
•
Thank you for buying this product.
•
Please read through these operating instructions, so you will know how to operate your
equipment properly. After you finished reading the instructions manual, put it in a safe place
for future reference.
CAUTION
The lightning flash is intended to alert the user to the presence of dangerous voltage
within the product’s enclosure, and touching the internal components may result in
a risk of electric shock to persons.
The exclamatory mark is intended to alert the user to the presence of important
operating instructions.
RISK OF ELECTRIC
SHOCK
DO NOT OPEN
CAUTION
To reduce the risk of electric shock, do not remove the cover (or back). Do not open
the unit. For service, please refer to qualified service personnel.
•
Don’t install the unit in a place exposed to heating sources or direct sunshine.
•
Don’t install the unit in a place exposed to moisture or rain.
•
The apparatus shall not be exposed to dripping or splashing and any object filled with liquids,
such as vases shall not be placed on it.
•
Minimum distances 30 cm around the apparatus for sufficient ventilation.
•
The ventilation should not be impeded by covering the ventilation openings with items, such
as newspapers, table-cloths, curtains, etc.
•
No naked flame sources, such as lighted candles, should be placed on the apparatus.
•
Switch off the unit when you don’t use it. Switch off the unit and disconnect it from the AC power
supply when it is not being used for a long time.
•
When the mains plug or an appliance coupler is used as the disconnect device, the disconne
-
ct device shall remain readily operable. To be completely disconnected the power input, the
mains plug of apparatus shall be disconnected from the mains completely.
•
The main plug of apparatus should not be obstructed or should be easily accessed during
intended use.
•
Use a soft and clean rag to clean the outside of the unit . Never clean it with chemicals or
detergent.
NOTES
When the unit is not providing the main function for 15 minutes, the unit will automati
-
cally switch into standby mode. To turn on the unit again, press
“FUNCTION/STANDBY” button.
Electrostatic Discharge hints – The unit may reset or may not reset to normal opera
-
tion mode due to electrostatic discharge, just switch it off and reconnect again.
Summary of Contents for BPS 626
Page 32: ......
