Godrej Appliances Eyetrace Elite ET-8D12E, User Manual

Page: 14 / 41

14
Special Function:
1. Preset.
Set a location for the preset, calls the preset points, PTZ automatically turns to the set position.
1) Preset option
Set a location for the preset, procedure is as follows:
Step 1:I
n picture 3.10, clicking the direction buttons will turn into preset position, click the 'set' button to enter Picture 3.11.
Step 2:
Click the 'Preset' button, then write the preset points in the input box.
Step 3:
Click 'Set' button, return to the picture 3.10. Complete setup that is the preset points and preset position corresponds to the values entered.
DEL Preset
: After entering preset points, click 'Del Preset' button to remove the preset.
2) Preset point calls
In picture 3.10, click 'Page switch' button, enter PTZ control interface as shown in picture 3.12. In the input blank, write the preset point number, then click 'Preset' button,
PTZ turns to the corresponding preset point.
Picture 3.11 Preset Settings Picture 3.12 PTZ Control Picture 3.13 Tour between point settings Picture 3.14 Scan Setup
2. Tour between Points
Multiple preset points connected tour line, call tour points, the PTZ run around on the line.
1)
Tour between points settings
Tour line is connected by multiple preset points, setting procedure is as follows:
Step 1:
In picture 3.10, the Direction key will turn PTZ to designated location, click 'Set' button to enter Picture 3.13.
Step 2:
Click 'Tour' button, then write proper values in the 'Preset' box, then click 'Add preset' button and complete settings (also can add or delete tour which has been set
up).
Step 3:
Repeat step 1 and step 2, until all the points in the preset designated tour is set.
Del Preset:
Please input preset value in the box, click 'Del Preset' button to remove the preset points.
Del Tour:
Input the number of tour line, click 'Del Tour' button to remove the tour lines set.