Setting the Transmitter
Multi Flash Parameter Setting
1. Enter into multi flash mode before setting.
2. Long press the <MODE> Button to enter multi
flash parameter setting menu.
3. Then, P (output value), T (flash times) and H
(flash frequency) will be displayed on the LCD
panel.
4. Short press the <GR> Button to choose the
settings. Turn the Select Dial to change the
blinking setting amount. Continue to press the
<GR> Button until all the amounts are set.
Then, short press the <MODE> Button to exit.
As flash times are restricted by flash output value and flash frequency, it might get automatic
adjustment.
The times that transported to the receiver end are a real flash time, which is also related to the
camera’s shutter setting.
X1T-N trans camera flash or X1R-N re camera flash uses multi flash function can
only have one flash, which is determined by Nikon Communication Protocol. However, TT685N and
AD360II can be triggered normally when working as receivers.
Setting the Transmitter
Group Settings
1. Long press the <GR> Button to set all the groups that in the same modes simultaneously.
2. The settings of the groups which are in the same mode with the current group will blink. Turn
the Select Dial to change the settings.
3. If the current group is in the M mode, all the other groups which are in the M mode will change
their power output value simultaneously. The power output value is changeable from 1/1 full
power to 1/128th power in 0.3 stop increments, until one of the group’s setting turns to the
maximum(1/1) or the minimum(1/128). If the current group is in the TTL mode, all the other
groups which are in the M mode will change their FEC amount simultaneously. The FEC
amount is changeable from -3 to 3 in 0.3 stop increments, until one of the group’s setting turns
to the maximum(3) or the minimum(-3). If the current group is in the -- mode (flash off), the
amounts will not change.
4. Short press the <GR> Button again to confirm the setting.
Test Flash
1. Press the <TEST> Trigger Button to see the
whether flash will fire normally or not.
2. Fully press the <TEST> Trigger Button, and the
Status Indicator Lamp turns red and the flash on
the receive end can be triggered.
3. Use the transmitter to control camera to focus or
shoot, and the transmitter is connecting to the
camera (do not connect to the flash) now.
4. In the standby mode, press the TEST Button can
wake up the receiver.
5. The settings on the transmitter end will
synchronize to the receiver end at the same time.
- 32 -
- 31 -