Note:
1. The Dial of the transmitter and the receiver must be set to the same grade. Otherwise, the receiver
does not response.
2. Flash triggering is only related with Channel Select Switch. The Power-Control Group Select Dial
only decides which flash or flash group to be controlled.
Other Buttons
1. Set Button (SET)
----Press the Set button and settings on the transmitter will be communicated with the flash through the
receiver.
will blink for sec. on the LCD display.
----Press and hold the Set button for 2 sec. to switch the power-ratio display mode.
2. Buzz Switch (BUZZ)
Press the Buzz Switch to turn the buzzer on or off. When the buzzer is turned on,
will be shown on
the LCD display.
3. Modeling Lamp / AF-Assist Beam Switch (LAMP)
Press the switch to turn the modeling lamp or AF-assist beam on or off. When the lamp or beam is
turned on,
will be shown on the LCD display.
4. <
－
><
＋
> Button
Press the <
－
> or <
＋
> button to decrease or increase the power ratio. The power range is “OF,
5.0~10” for studio flashes and “OF, 1/128~1/1” for shoe mount flashes. “OF” means the flash triggering
function is shut down on the flash.
5. Test Button (TEST)
Press Test Button to fire the flash. Both the indicators on the transmitter and the receiver will blink.
Using the Trigger Set
■
Wireless Adjusting Flash Settings
The trigger set can wireless adjust the following settings: the flash power ratio, the on-or-off of the
buzzer and the modeling lamp or the AF-assist beam, as well as the power-ratio display mode.
1. On the transmitter and the receiver, set the Channel Select Switch to the same position and the
Power-Control Group Select Dial to the same grade.
2. Insert the receiver into the Wireless Control Port of the flash unit. Then power the flash on.
3. Adjust the flash settings on your transmitter.
