Godox AD100Pro, User Manual

Page: 18 / 121

18
The Reason & Solution of Not Triggering in Godox 2.4G
Wireless
Disturbed by the 2.4G signal in outer environment (e.g. wireless base station, 2.4G
Wi-Fi router, Bluetooth, etc.)
•
To adjust the channel CH setting on the flash trigger (add 10+ channels) and use
the channel which is not disturbed. Or turn off the other 2.4G equipment in
working.
Please make sure that whether the flash has finished its recycle or caught up with
the continuous shooting speed or not (the flash ready indicator is lighten) and the
flash is not under the state of over-heat protection or other abnormal situation.
•
Please downgrade the flash power output. If the flash is in TTL mode, please try
to change it to M mode (a preflash is needed in TTL mode).
Whether the distance between the flash trigger and the flash is too close or no
•
P lease turn on the “close distance wireless mode” on the flash trigger (<0.5m):
X2 & X1 series: press the test button and hold on, then turning it on until the flash
ready indicator blinks for 2 times.
XPro series: Set the C.Fn-DIST to 0-30m.
Whether the flash trigger and the receiver and equipment are in the low battery
states or not
• Please replace the battery (the flash trigger is recommended to use 1.5V
disposable alkaline battery).