Godiva Hale SmartFOAM 1.7AHP, Setup Manual, Page: 4 / 15

Page 3
SmartFOAM
SAFETY
IMPORTANT!
THE HALE SMARTFOAM MODELS 2.1A AND
1.7AHP CLASS “A” ELECTRONIC FOAM
PROPORTIONING SYSTEMS ARE DESIGNED FOR
OPTIMUM SAFETY OF ITS OPERATORS AND TO
PROVIDE RELIABLE AND SAFE FOAM
CONCENTRATE INJECTION. FOR ADDED
PROTECTION AND BEFORE ATTEMPTING
INSTALLATION OR OPERATION PLEASE FOLLOW
THE SAFETY GUIDELINES LISTED IN THIS
SECTION AND ADHERE TO ALL WARNING,
DANGER, CAUTION AND IMPORTANT NOTES
FOUND WITHIN THIS GUIDE.
THIS SECTION ON SAFETY MUST BE CAREFULLY
READ, UNDERSTOOD AND ADHERED TO
STRICTLY BY ALL INSTALLERS AND OPERATORS
BEFORE ATTEMPTING TO INSTALL OR OPERATE
THE SMARTFOAM PROPORTIONING SYSTEM.
INCORPORATE THE WARNINGS AND CAUTIONS
AS WRITTEN WHEN DEVELOPING
DEPARTMENTAL APPARATUS OPERATING
PROCEDURES.
SmartFOAM is a trademark of Hale Products,
Incorporated. All other brand and product names
are the trademarks of their respective
holders.
GUIDELINES
READ ALL INSTRUCTIONS THOROUGHLY BEFORE
BEGINNING ANY INSTALLATION OR OPERATION
PROCESS.
❑
Installation should be performed by a trained and
qualified installer, or your authorized Hale
Products service representative.
❑
Be sure the installer has sufficient knowledge,
experience and the proper tools before attempting
any installation.
❑ Make sure proper personal protective equipment is
used when operating or servicing apparatus.
❑
A foam tank low level sensor must be utilized to
protect the Hale Foam proportioner from dry
running.
Failure to use a low level sensor with the
Hale Foam system voids warranty.
❑
DO NOT permanently remove or alter any
guard or insulating devices, or attempt to
operate the system when these guards are
removed.
❑
Make sure all access/service panels and covers
are installed, closed and latched tight, where
applicable.
❑
DO NOT remove or alter any hydraulic or
pneumatic connections, electrical devices, etc.
DO NOT tamper with or disconnect safety
features or modify protective guards (such as
covers or doors). DO NOT add or remove
structural parts.
Doing so voids the warranty.
Any of the above could affect system capacity and/or
safe operation of the system and is a serious safety
violation which could cause personal injury, could
weaken the construction of the system or could affect
safe operation of the SmartFOAM Proportioning
System.
WARNING!
NO MODIFICATIONS OR ADDITIONS MAY BE
MADE TO THE SMARTFOAM PORPORTIONING
SYSTEM WITHOUT PRIOR WRITTEN PERMISSION
FROM:
HALE PRODUCTS, INC
607 NW 27
th
Avenue
Ocala, Florida 34475 USA
Telephone: 352-629-5020
FAX: 800-533-3569
❑
All electrical systems have the potential to
cause sparks during service. Take care to
eliminate explosive or hazardous environments
during service and/or repair.
❑
To prevent electrical shock always disconnect the
primary power source before attempting to service
any part of the Hale Foam system.
❑ To prevent system damage or electrical shock
the main power supply wire is the last
connection made to the Hale Foam motor
controller.
❑
Release all pressure then drain all concentrate and
water from the system before servicing any of its
component parts.