Mini toggle switches
There are two mini toggle switches on the guitar.
Switch #1
is a three-way pick-up selector that allows you to
switch between the acoustic/electric and synth voices.
This switch is designed to work with the 13-pin connection as
follows:
Position 1: Acoustic/Electric
Position 2: Acoustic/Electric/synth sounds
Position 3: Synth only
*The mini 3-way switch is disabled as described above when using 1/4"
jacks.
Switch #2
is a momentary switch. A momentary switch always
springs back to its starting position, which in this case, is the
center position. The momentary switch duplicates the func-
tions of the S1/S2 buttons from Roland's GK pickup. (See
your Roland GR manual for details). This switch can be
assigned to access the tuner, wah pedal, or to select sounds
(patches) on the synth. Clicking the momentary switch down-
wards duplicates the S1 function and clicking it upwards dupli-
cate the S2 function.
Care and Maintenance
To avoid drying out your fingerboard apply lemon oil on a soft
cloth and then to your fingerboard. Allow the ebony to soak in
the oil for a few minutes before removing the excess. This
should be done with the strings removed and at least once
every year. The easiest way to keep your guitar clean is by
simply using a polishing cloth without using any polishes at all.
However if you are going to use a polish please use a non-
abrasive non-wax based polish. Apply the polish on a cloth
first. Do not spray it directly on to the guitar. After you have
polished the area you are working on turn the cloth over to a
'dry' side and remove any excess residue.
Additional information
Tuners
The LGXT features front-
loaded locking tuners for easy
string change and better into-
nation. Simply turn the locking
tuner counter clock-wise to
loosen, insert string, tighten
the locking tuner by turning
clock-wise and you're ready to
tune.
Pre-Amp
The built in active pre-amp for
the bridge transducers is powered by a single 9-volt battery
accessible via a small compartment on the back of the guitar.
The pre-amp is activated when the guitar is plugged in.
Therefore, to avoid draining the battery please make sure to
disconnect your cable when the guitar will not be used for a
extended period of time. If the sound of the bridge transducers
begin to sound thin or fuzzy, a battery change is overdue.
Battery life is approximately 300 hours.
Double function Truss Rod
The LGXT's neck is reinforced by a sophisticated truss rod
system, the truss rod provides for easy adjustment when the
neck reacts to changes in relative humidity. Truss rod adjust-
ments should only be made by a qualified guitar technician.
Double Action Truss Rod
tightens both ways
1/ Truss rod in 'flat' (no tension) position
2/ Tightening the truss rod clockwise causes the neck
to become increasingly convex (over) = less relief.
3/ Tightening the truss rod counter-clockwise causes
the neck to become concave (under) = more relief.
The double action (dual-function) system permits
accurate adjustments to the neck in both directions.
Truss Rod Adjustment
Tu
rn
in
g
w
re
nc
h
to
rig
ht ar
cs rod conv
ex
Truss Rod Adjustment
Tu
rn
ing
wre
nch to left ar
cs r
od
co
n
ca
ve
WARNING: Over adjusting your truss rod can
cause irreparable damage to your guitar and
therefore should only be handled by a
qualified guitar technician.
Summary of Contents for LGXT
Page 1: ......
